M-System 3G L200 21pcs Atlas

Easy to install – each point is fitted individually (installation of disc anchors and lining boards) and can be done by one person.
Quick progress of work – fixing full-size boards is limited to two stages: drilling holes where the anchors will be inserted and screwing plasterboards to the discs with steel screws.
Smooth adjustment of space between boards and substrate as well as the inclination angle of the lining (±27°) – the distance between plasterboards and substrate can be adjusted at will, regardless of the wall geometry or the plasterwork, within the range of 10-200 mm, and – in case of ceilings – with extensions even up to 500 mm.
No requirements concerning the preparation of substrate – no levelling, hacking off cracked plasterwork, priming, etc. is necessary – plasterboards can be accurately fixed upon very uneven or cracked plasterwork as well as upon inclined walls, etc.
Possibility of correcting the wall geometry in case of not right-angled concave and convex corners – the anchors can be used additionally for plasterboards bonded to substrates of major irregularities (> 20 mm). They can then be fixed locally in the most uneven places instead of bonding the boards with adhesive.
Collision-free distribution of electrical installations, water and sewage pipes as well as ventilation shafts under the plasterboard lining – in case of existing pipes or cables, the anchors ensure quick fixing of plasterboards and keeping necessary stability.

ATLAS M-system 3G can be combined with:
– traditional technologies, such as ceilings coated with gypsum plasters,
– elements of two or more layer ceilings fixed with 120 PP, 120 ZN or 120 N anchors,
– plasterboards fixed to frames.

Reduced risk of cracks – point fixing compensates for tensions of individual boards during the installation. Once plastered, the boards form a rigid structure. There’s no tension so no cracks would appear at the joints. The structure is separated from the cladding of the adjoining walls and ceiling by expansion joints and therefore keeps space for further deformations.
Quick installation of plasterboards – partially lowered ceilings, casings upon walls, etc. can be quickly installed in the relevant zones of walls and ceilings next to previously plastered elements in order to complete the job.
Possibility of reduction of space between the lining and the substrate down to 1 cm – in order to minimize the loss of space in a room.
Easy and safe to transport and store – system elements are small and can be transported with cars, which is not possible in the case of solutions with metal studs. Elements do not take up much storage space and can be stored in limited areas outdoors or in a car.