USE
CEKOL GS-150 is used for patching and smoothing walls and ceilings inside buildings. It serves as an excellent base for finishing coats such as CEKOL C-45 Finisz.
CHARACTERISTICS
It is a compound of synthetic gypsum, mineral fillers and modifiers. The finish can be obtained by sanding the surface or wet finishing.
- Mixing ratio: approx. 0,45 l water for 1 kg of powder.
- Pot life: 60 minutes
- Consumption: approx 1,5 kg/m²/mm
- Layer thickness: 1 to 10 mm
- Ambient application temperature :+5 °C to +25°C
- Initial bonding: ≥ 60 min
SUBSTRATE PREPARATION
The substrate should be clean, tight, free of grease. Using a spatula, remove the remains of emulsion and oil paints, and loose grains of sand. The substrate should be clean, tight and free of grease. Highly absorbent substrates should be primed with a deep penetrating primer. Smooth substrates and substrates with low water absorption, as well as in the case of wet smoothing, must be primed with a bonding primer.
PLASTERING
The mortar should be prepared by pouring 1 kg of powder to about 0.4 litres of water and mixing it thoroughly. 0,45 l of water. Mix thoroughly and apply with a trowel. The mortar should be used within 60 minutes. Use only stainless steel or plastic tools. Sandable after initial hardening. Paint after the plaster is fully dry.
STORAGE
Keep in the original packaging in a dry and dark place, away from sources of heat. Protect from excessive temperature and frost.
